![]() Luckily, one great solution that you can rely on is applying a premium quality boat wax. Also, giving your boat a subtle finish and maximum protection is a little tough to achieve. It is saddening to see your most prized boat faded and filled with some unsightly imperfections. Since it is inevitable for boats to get old, damaged, faded, and oxidized, buying the best boat wax becomes necessary. ![]() Boats are expensive investments that must be treasured for a lifetime. This is specifically true for boat owners who consider their watercraft a great possession. Abrasive cleaners, polishes, rubbing compounds or chemical paint strippers will remove the RejeX film.We are commonly blinded by the gloss and luster of the impressive boats that we see whenever we tour around. If a RejeX-treated surface needs repainting, normal paint preparation is all that's required. As we've already said, RejeX leaves a shinier, longer-lasting finish than wax and the wax can't adhere well to RejeX! RejeX can be used over existing wax however, the duration of protection will be reduced as the softer underlying wax degrades comparatively quickly. RejeX has a higher refractive index than waxes, so it produces richer, deeper looking colors and a lustrous long-lasting finish. RejeX can be applied in multiple coats, allowing 8 hours curing time between coats for deeper color and greater depth of gloss. RejeX is not meant to be used on porous surfaces, highly oxidized painted surfaces, or to fill fine scratches. Rejex protects and beautifies painted metal, glass, acrylic, gel coat, fiberglass, glossy plastic and polished metal surfaces! before it has cured, the contaminants may interfere with the film, preventing the RejeX from achieving it's maximum performance and durability. If the coating is exposed to contamination such as oil, fuel, soot, water, cleaners, etc. It is very important to allow RejeX to cure for 12 hours after the haze has been wiped off. RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 12 hours.Ĭuring is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to polymerize (crosslink) into a crystal-clear, impervious film. If the surface is too hot, the coating will cure before it has properly bonded to the surface, and it wonメt perform up to its potential. RejeX should be applied to a cool (less than 85° F) dry surface out of direct sunlight. RejeX contains none of the free silicone oils found in some other products that are known to contaminate paint and cause problems when repainting. It's easy to apply and produces a deep, lustrous shine that outlasts the most popular waxes by months. It also makes graffiti easy to remove and can be applied to windshields to repel rain. This very thin film less than a micron thick prevents stains and adhesion of common contaminants such as exhaust, bugs, oil, tree sap, bird droppings, road grime, brake dust, etc. RejeX is a thin-film polymer coating designed to provide a high-release protective finish for vehicles of all kinds. ![]()
0 Comments
Leave a Reply. |